Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: General description

Installation
DRIVE SHAFT SYSTEM > Front Hub Unit BearingINSTALLATION1. Place the front brake back plate between the front axle housing and the front hub unit bearing, and tighten the bolt.CAUTION:• Do not ...

Caution
DRIVE SHAFT SYSTEM > General DescriptionCAUTION• When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if ...

Other materials:

Abbreviation in wiring diagrams
WIRING SYSTEM > Basic Diagnostic ProcedureABBREVIATION IN WIRING DIAGRAMSAbbr.Full nameABSAnti-lock Brake SystemACCAccessoryA/CAir ConditionerASSYAssemblyATAutomatic TransmissionA/FAir/Fuel (air fuel ratio sensor)ATFAutomatic Transmission FluidAUXAuxiliary Audio Input TerminalAWDAll Wheel DriveB, ...

Ebd warning light, abs warning, vdc off indicator light, vdc warning light and vdc indicator light do not come on
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Warning Light Illumination PatternEBD WARNING LIGHT, ABS WARNING, VDC OFF INDICATOR LIGHT, VDC WARNING LIGHT AND VDC INDICATOR LIGHT DO NOT COME ONDetecting condition:Defective combination meterTrouble symptom:When the ignition switch is turned to ON ...

Head restraint angle adjustment
The angle of the head restraint can be adjusted in several steps. While maintaining a suitable driving posture, adjust the head restraint to a position where the back of your head is as close to the head restraint as possible. To tilt: Tilt the head restraint by hand to the preferred p ...

© 2016-2025 Copyright www.sucross.com