Subaru Crosstrek Service Manual: Caution

• When performing any work, always wear work clothes, a work cap and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.

• Remove contamination including dirt and corrosion before removal, installation, disassembly or assembly.

• When performing a repair, identify the cause of trouble and avoid unnecessary removal, disassembly and replacement.

• Some vehicle components are extremely hot immediately after driving. Be wary of receiving burns from heated parts.

• Use SUBARU genuine grease, the recommended or equivalent. Do not mix grease etc. of different grades or manufacturers.

• Be sure to tighten fasteners including bolts and nuts to the specified torque.

• Always use the jack-up point when the shop jacks or rigid racks are used to support the vehicle.

• Apply grease onto sliding or revolving surfaces before installation.

• Be sure that the surface of brake disc, brake pad or brake shoe is free from grease or oil.

• Do not secure a part in a vise directly. Place cushioning materials such as wood blocks, aluminum plates, or waste cloth between the part and the vise.

• When the suspension-related components have been removed or replaced, perform “VDC sensor midpoint setting mode” of the VDC. VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT"> VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT"> VDC Control Module and Hydraulic Control Unit (VDCCM&H/U) > ADJUSTMENT">

General description

Specification

Other materials:

Dtc c0042 power supply voltage failure
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0042 POWER SUPPLY VOLTAGE FAILUREDTC detecting condition:Improper VDCCM&H/U power supply voltageTrouble symptom:• ABS does not operate.• EBD may not operate.• VDC does ...

Dtc u0422 invalid data received from body control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0422 INVALID DATA RECEIVED FROM BODY CONTROL MODULEDTC DETECTING CONDITION:Defective data was transmitted from body integrated unit.TROUBLE SYMPTOM:Cooperation control with body integrated unit does not operate ...

Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Front Differential AssemblyINSTALLATION1. Install the differential side retainers using ST.ST 18630AA010WRENCH COMPL RETAINER2. Install the taper roller bearing outer race to the transmission case.3. Install the front differential assembly.NOTE:Be ca ...