Subaru Crosstrek Owners Manual: Enabling functions

Subaru Crosstrek Owners Manual / Keys and doors / Keyless access with push-button start system (if equipped) / Disabling keyless access function / Enabling functions

When the procedure to disable the functions is performed again, a chirp sound will be heard, and the functions are enabled.

NOTE

The keyless access function will be enabled only if you perform the procedure in the same manner you disabled the function (for example, when disabling by operating the driver's door, the function will not be enabled even if you operate the access key).
Press the push-button ignition switch if you do not know the procedure in which the keyless access function was disabled.
When disabling by operating the driver's door: a chirp will not be heard
When disabling by operating the access key: a chirp will be heard

When access key does not operate properly

Refer to "Access key - if access key does not operate properly" 9-17.

Replacing battery of access key

Refer to "Replacing battery of access key" 11-42.

Replacing access key

Access keys can be replaced at SUBARU dealers. For more details, contact a SUBARU dealer.

Disabling functions

By operating the access key If you have registered a PIN code for PIN Code Access, you can disable the keyless access function by operating the access key. For details about registering a PIN cod ...

Certification for keyless access with push-button start system

U.S.-spec. models FCC ID: HYQ14AHC FCC ID: HYQ13CZZ FCC ID: Y8PSSPIMB02 FCC ID: Y8PSSPLF02 CAUTION FCC WARNING Changes or modifications not expressly approved by the party responsible for com ...

Other materials:

Operation
EyeSight (DIAGNOSTICS) > Diagnostic Code(s) DisplayOPERATION1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Select System» display, select ...

Dtc b2329 rear radar axis alignment incomplete
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2329 REAR RADAR AXIS ALIGNMENT INCOMPLETEDTC DETECTING CONDITION:Axis adjustment of the radar sensor has failed.(Forced termination of the Subaru Select Monitor, improper loca ...

If your vehicle is involved in an accident
To restart the engine when involved in an accident CAUTION If your Subaru Ascent has been involved in an accident, carefully inspect the ground beneath the vehicle before attempting to restart the engine. If any fuel leakage is detected, do not start the engine under any circumstances, as t ...