Subaru Crosstrek Service Manual: Removal

CAUTION:

Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">

1. Operate the power window switch to close the front door glass.

2. Turn the ignition switch to OFF.

3. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. NOTE">

4. Remove the trim panel - front door. Door Trim > REMOVAL">

5. Remove the sealing cover. Front Sealing Cover > REMOVAL">

6. Remove the front door impact sensor.

(1) Remove the front door inner pad (a).

CAUTION:

If the clip is damaged, replace it with a new part because the panel assembly - front door may be deformed.

(2) Remove the nuts and then remove the front door impact sensor.

(3) Disconnect the airbag connector and remove the front door impact sensor. Airbag Connector > PROCEDURE">

Installation

Front sub sensor

Other materials:

Installation
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Fuel InjectorINSTALLATIONInstall in the reverse order of removal.NOTE:• Use new fuel injector holder, O-rings, rubbers and seal rings.• Install the fuel injector so that the connector joint faces the connector rotation stopper side of the fuel pip ...

Dtc c1732 lateral g sensor
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1732 LATERAL G SENSORDTC detecting condition:Defective lateral G sensorTrouble symptom:• ABS does not operate.• VDC does not operate.• Hill start assist does not operate.ST ...

Electrical component location Location
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Combination meter(2)MFD(3)Data link connector ...