AIRBAG SYSTEM > Front Door Impact Sensor
INSTALLATION
CAUTION:
Do not reuse the bolt and nut.
Always replace with the specified new bolts and nuts.
1. Before installation, inspect the following items and replace any faulty part with a new part.
• The front door impact sensor or connector is damaged.
• Inner panel area of the panel assembly - front door is deformed.
• Side airbag module has been activated.
Tightening torque:
Front door impact sensor: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
2. Install each part in the reverse order of removal.
RemovalInspection mode Procedure
ENGINE (DIAGNOSTICS)(H4DO) > Inspection ModePROCEDUREPerform the diagnosis shown in the following DTC table.When performing the diagnosis not listed in “List of Diagnostic Trouble Code (DTC)”, refer to the item on the drive cycle. Drive Cycle">DTCItemConditionB1570ANTENNA — ...
Specification
VEHICLE DYNAMICS CONTROL (VDC) > General DescriptionSPECIFICATIONItemSpecification or identificationABS wheel speed sensorABS wheel speed sensor gap (for reference)Front0.77 — 1.43 mm (0.030 — 0.056 in)Rear0.44 — 1.76 mm (0.017 — 0.069 in)Identifications of harness (symbol)FrontRHZ1LHZ2Re ...
Tilt/telescopic steering wheel
WARNING
Do not adjust the steering wheel
tilt/telescopic position while driving.
This may cause loss of
vehicle control and result in
personal injury.
If the lever cannot be raised to
the fixed position, adjust the
steering wheel again. It is dangerous
to drive without locking
...