Subaru Crosstrek Owners Manual: Activating and deactivating the alarm system
To change the setting of your vehicle's alarm system for activation or deactivation, do the following.
1. Disarm the alarm system. Refer to "Disarming the system" 2-30.
2. Sit in the driver's seat and shut all doors and the rear gate.
3. Turn the ignition switch to the "ON" position.
4. Hold down the REAR (UNLOCK) side of the driver's power door locking switch, open the driver's door within the following 1 second, and wait 10 seconds without releasing the switch. The setting will then be changed as follows.
If the system was previously activated: The odometer/trip meter screen displays as follows and the horn sounds twice, indicating that the system is now deactivated.
- "AL oF" (models with type A combination meter)
- "ALOF" (models with type B combination meter)
If the system was previously deactivated: The odometer/trip meter screen displays as follows and the horn sounds once, indicating that the system is now activated.
- "AL on" (models with type A combination meter)
- "ALON" (models with type B combination meter)
NOTE
You may have the above setting change done by your SUBARU dealer.
System operation
The alarm system will sound the following
alarms when triggered.
The vehicle's horn will sound for 30
seconds.
The hazard warning flashers will flash
for 30 seconds.
If any of the doors ...
If you have accidentally triggered the alarm system
To stop the alarm
Do any of the following operations
Press any button on the access key/
remote transmitter.
Turn the ignition switch to the "ON"
position (models without "keyless access
...
Other materials:
Dtc p0713 transmission fluid temperature sensor "a" circuit high
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0713 TRANSMISSION FLUID TEMPERATURE SENSOR "A" CIRCUIT HIGHDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Excessive shift shock• Shift ch ...
Operation
ENTERTAINMENT > Navigation SystemOPERATION1. SUBARU STARLINK CONNECTION ID DISPLAY1. Turn the ignition switch to ACC.2. Press the AUDIO/TUNE knob (b) five times with the HOME button (a) pressed to display the {Service Menu} screen.3. Touch the {Product Information} (c) to display the {Product Inf ...
Specification
WIPER AND WASHER SYSTEMS > General DescriptionSPECIFICATIONFront wiper motorInput12 V — 72 W or lessRear wiper motorInput12 V — 42 W or lessFront washer motorPump typeCentrifugalInput12 V — 60 W or lessRear washer motorPump typeCentrifugalInput12 V — 36 W or less ...
