Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Precautions when working with the parts mounted on the vehicle

Subaru Crosstrek Service Manual / Wiring system / Working precautions / Precautions when working with the parts mounted on the vehicle

WIRING SYSTEM > Working Precautions

PRECAUTIONS WHEN WORKING WITH THE PARTS MOUNTED ON THE VEHICLE

1. When working under a vehicle which is jacked-up, always be sure to use rigid rack.

2. The parking brake must always be applied during working. Also, in automatic transmission vehicles, keep the select lever set to the P (Parking) range.

3. Be sure the workshop is properly ventilated when running the engine. Further, be careful not to touch the belt or fan while the engine is operating.

4. Be careful not to touch hot metal parts, especially the radiator and exhaust system immediately after the engine has been turned off.

Working precautions
...

Precautions in trouble diagnosis and repair of electric parts
WIRING SYSTEM > Working PrecautionsPRECAUTIONS IN TROUBLE DIAGNOSIS AND REPAIR OF ELECTRIC PARTS1. The battery cable must be disconnected from the battery’s (−) terminal, and the igniti ...

Other materials:

How to contact the vehicle manufacturer concerning modifications for persons with disabilities that may affect the advanced airbag system
Changing or moving any parts of the front seats, rear seat, seatbelts, front bumper, front side frame, radiator panel, instrument panel, combination meter, steering wheel, steering column, tire, suspension or floor panel can affect the operation of the SUBARU advanced airbag system. If you ha ...

Sliding moonroof
Open Close To open: Press and hold the rear side of the "OPEN/CLOSE" switch. The sun shade will also be opened together with the moonroof. The moonroof will stop at a position approximately 1.6 in (4 cm) away from the fully opened position. Press and hold the rear side of the swit ...

Dtc u0100 lost communication with ecm/pcm a
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”Detected when CAN data from the engine control module (ECM) does not arrive.NOTE:Perform the diagnosis for LAN system. Basi ...

© 2016-2025 Copyright www.sucross.com