Subaru Crosstrek Owners Manual: Tripped sensor identification
The security indicator light flashes when the alarm system has been triggered.
Also, the number of flashes indicates the location of unauthorized intrusion or the severity of impact on the vehicle.
When the ignition switch is turned to the "ON" position, the indicator light will light for 1 second and then flash as follows.
- When a door or the rear gate was opened: 5 times
- When the ignition switch was turned to the "ON" position: 3 times
- When a strong impact or multiple impacts were sensed: twice (only models with shock sensors (dealer option))
- When a light impact was sensed: once (only models with shock sensors (dealer option))
NOTE
Any of the above indicator light flashings will recur each time the ignition switch is turned to the "ON" position.
Rearming the alarm system cancels the flashing.
Passive arming (models without "keyless access with push-button start
system")
Passive arming mode
When passive arming mode has been
programmed by the dealer, arming of the
system is automatically accomplished
without using the remote transmitter. Note
that in this mode, DO ...
Shock sensors (dealer option)
The shock sensors trigger the alarm
system when they sense impacts applied
to the vehicle and when any of their
electric wires are cut. The alarm system
causes the horn to sound and the hazard
wa ...
Other materials:
Removal
DRIVE SHAFT SYSTEM > Propeller ShaftREMOVALCAUTION:• Before removing propeller shaft, wrap metal parts with a cloth or rubber material.• Do not disassemble the center EDJ of the propeller shaft.• Before removing propeller shaft, wrap the metal parts attached to the rubber boot o ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Oil Control SolenoidREMOVALCAUTION:If the engine oil is spilt over exhaust pipe or the under cover, wipe it off with cloth to avoid emission of smoke or causing a fire.1. INTAKE SIDE1. Disconnect the ground cable from battery.2. Remove the air intake duct. (R ...
List
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Code(s) DisplayLISTDTCItemNoteU0073CONTROL MODULE COMMUNICATION BUS OFF Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC U0073 CONTROL MODULE COMMUNICATION BUS OFF">U0100LOST COMMUNICATION WITH ECM/PCM “A” Diagnostic ...
