HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Compressor Oil
ADJUSTMENT
• If a component has been replaced, add an appropriate amount of compressor oil (same as the amount of remaining oil in removed component).
• When replacing the compressor assembly, the new compressor assembly will already have the specified amount of oil in it. Adjust the oil amount (so that the amount remains the same as that of the removed compressor assembly) and install the new compressor assembly.
NOTE:
Since the hygroscopicity of compressor oil is high, perform this series of works quickly.
Compressor oil
ProcedureRemoval
SECURITY AND LOCKS > Keyless Access Outdoor AntennaREMOVAL1. FRONT ANTENNACAUTION:Do not remove the antenna from the front door outer handle.If replacement is needed, replace the front outer handle assembly as a set.Remove the handle - door outer. Front Outer Handle > REMOVAL">2. REAR ...
Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Inhibitor SwitchREMOVAL1. Shift the select lever to “N” range.2. Disconnect the ground cable from battery. NOTE">NOTE:For model with battery sensor, disconnect the ground terminal from battery sensor.3. Lift up the vehicle.4. Remove ...
Installation
MECHANICAL(H4DO) > V-beltINSTALLATION1. V-BELTInstall in the reverse order of removal.CAUTION:• When reusing the V-belt, wipe off dust and water with cloth.• Do not use the V-belt if there is any oil, grease or coolant on the belt.• Be careful not to rub the V-belt end surface w ...