Subaru Crosstrek Service Manual: Procedure
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Compressor Oil
PROCEDURE
NOTE:
Before making repairs, perform the oil return operation to return the compressor oil in circulation with the refrigerant to the compressor assembly.
1. Increase the engine speed to 1,500 r/min.
2. Turn the A/C switch to ON.
3. Turn the temperature control dial to LO (MAX COOL).
4. Turn the FRESH/RECIRC switch to RECIRC position.
5. Turn the fan dial to HI (MAX).
6. Leave in this condition for 10 minutes.
Adjustment
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Compressor OilADJUSTMENT• If a component has been replaced, add an appropriate amount of compressor oil (same as the amount of remaining oil in remo ...
Condenser
...
Other materials:
Removal
SECURITY AND LOCKS > Rear Gate Latch and Actuator AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear gate. Rear Gate Trim > REMOVAL">3. Remove the latch and actuator - rear gate.(1) Disconnect the connector.(2) Remove the bolts, ...
Dtc p081a starter disable circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P081A STARTER DISABLE CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:Failure of engine to startCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode ...
Removal
EXHAUST(H4DO) > Front Exhaust PipeREMOVALCAUTION:Vehicle components are extremely hot after driving. Be wary of receiving burns from heated parts.1. Disconnect the ground cable from battery. NOTE">2. Lift up the vehicle.3. Remove the under cover. Front Under Cover > REMOVAL"> ...
