Subaru Crosstrek Service Manual: Inspection
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > General Description
INSPECTION
1. BASIC INSPECTION
Before performing the diagnosis, check the following items which may cause problems relating the wiper or light.
1. Check the battery. Battery">
2. Check the relay and fuse condition. Relay and Fuse">
3. Check the connecting condition of harness and harness connector.
2. FUNCTION CHECK
With the ignition switch ON and the lighting switch set at low beam, change the vehicle posture while the vehicle is stopped. Check that the beam moves, when the vehicle condition is kept for three seconds or more.
Preparation tool
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > General DescriptionPREPARATION TOOL1. SPECIAL TOOLILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS — SUBARU SELECT MONITOR 4Used for setting of each fu ...
Other materials:
Electrical specification
AIRBAG SYSTEM (DIAGNOSTICS) > Airbag Control Module I/O SignalELECTRICAL SPECIFICATION• Terminal numbers in airbag control module connector are shown in the figure.• The airbag warning light illuminates when the connector is removed from the airbag control module.ItemControl module te ...
Dtc b1610 front sub sensor rh failure
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1610 FRONT SUB SENSOR RH FAILUREDIAGNOSIS START CONDITION:Ignition voltage is 10 V to 16 V.DTC DETECTING CONDITION:Front sub sensor (RH) is faulty.If DTC B1610 is displayed, the circuit within the front sub sensor (RH) is faulty ...
Dtc p0752 shift solenoid "a" stuck on
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0752 SHIFT SOLENOID "A" STUCK ONDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Acceleration is poor during standi ...
