Subaru Crosstrek Owners Manual: Floor mat (if equipped)
CAUTION
If the floor mat slips forward and interferes with the movement of the pedals during driving, it could cause an accident. Observe the following precautions to prevent the floor mat from slipping forward.
- Be sure to use a genuine SUBARU floor mat or an equivalent designed with grommets in the correct locations.
- Make sure that the driver's floor mat is placed in its proper location and is correctly secured on its retaining pins.
- Do not use more than one floor mat.
Retaining pins are located on the driver's side floor.
The floor mat should be properly secured using the built-in grommets, by placing the grommets over the pins and pushing them downward.
Ashtray (dealer option)
CAUTION
Observe the following precautions.
Not doing so could result in a fire.
Always extinguish matches and
cigarettes before putting them
into the ashtray, and then close
the ashtray ...
Coat hook
A coat hook is attached to the rear
passenger's hand grip.
WARNING
Obey the following instructions.
Do not hang coat hangers or
other hard or pointed objects on
the coat hooks. Hang clo ...
Other materials:
Dtc u0100 lost communication with ecm/pcm a
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”Detected when CAN data from the engine control module (ECM) does not arrive.NOTE:Perform the diagnosis for LAN system. Basi ...
Canceling the function for meter/gauge needle movement upon turning on the
ignition switch
It is possible to activate or deactivate the
movement of the meter needles and
gauge needles that takes place when the
ignition switch is turned to the "ON"
position.
Type A combination meter
To change the setting, perform the following
procedure.
1. Turn the ignition switch to the "LOCK"/ ...
Inspection
ENTERTAINMENT > Diagnostics with PhenomenonINSPECTION1. POWER WILL NOT TURN ONWiring diagram:• Audio system: Audio System > WIRING DIAGRAM">• Navigation system: Navigation System > WIRING DIAGRAM">STEPCHECKYESNO1.CHECK CONNECTOR CONNECTION.Check that the connec ...
