Subaru Crosstrek Service Manual: Read diagnostic trouble code (dtc) Operation

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Headlight / Foglight» and then select «Enter».

5. On «Select Function» display, select «DTC».

NOTE:

• For detailed operation procedures, refer to “Application help”.

• For details concerning DTC, refer to “List of Diagnostic Trouble Code (DTC)”. List of Diagnostic Trouble Code (DTC)">

List of diagnostic trouble code (dtc) List

Blind spot detection/rear cross traffic alert (diagnostics)

Other materials:

Wiring diagram
LIGHTING SYSTEM > Stop Light SystemWIRING DIAGRAMRefer to “Stop Light System” in the wiring diagram.• Model without EyeSight: Stop Light System > WIRING DIAGRAM">• Model with EyeSight: Stop Light System > WIRING DIAGRAM"> ...

Installation
AIRBAG SYSTEM > Front Sub SensorINSTALLATIONCAUTION:• If the airbag has been activated, replace the front sub sensor with a new part.• Do not reuse the bolt and nut.Always replace with the specified new bolts and nuts.• When installing the sensor, insert the set pin on the backs ...

Inspection
BRAKE > Stop Light SwitchINSPECTION1. CLEARANCE CHECKNOTE:Check for clearance is applied only to LED model.1. Measure the clearance between the end of the stop light switch and the stopper.Specification:Clearance (A) of the stop light switch: 1 mm — 2 mm (0.04 in — 0.08 in)(a)Stop light switc ...