Subaru Crosstrek Service Manual: Operation
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Read Current Data
OPERATION
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Headlight / Foglight» and then select «Enter».
5. On «Select Function» display, select «Data Monitor».
NOTE:
For detailed operation procedures, refer to “Application help”.
List
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Read Current DataLISTItem NameContentStandardNoteTrip Count [count]Time stamp information, trip counter — — CountTime stamp information, orig ...
Other materials:
Dtc p0018 crankshaft position - camshaft position correlation bank 2 sensor a
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0018 CRANKSHAFT POSITION - CAMSHAFT POSITION CORRELATION BANK 2 SENSOR ADTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine stall• Improp ...
Electrical component location Location
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Electrical Component LocationLOCATION1. OUTSIDE VEHICLE(1)A/C compressor(3)Pressure switch(4)Ambient sensor(2)A/C relay 2. COMPARTMENT(1)Air mix door actuator LH*2(5)Intake door actuator(9)A/C control panel(2)In-vehicle sensor(6)Mode door actuator(10)Blow ...
Initial screen
When the ignition switch is in the "ACC" or
"ON" position, the initial screen will be
displayed and the system will begin
operating.
When using the SUBARU STARLINK
function (if equipped), the display screen
may be different from the screen above.
After a few seconds, the caution scr ...
