MECHANICAL(H4DO) > Crankshaft
SPECIFICATION
Refer to “Cylinder Block” for removal and installation procedures of the crankshaft. Cylinder Block > REMOVAL">
Cylinder Block > INSTALLATION">
Connecting rod Specification
Engine noise InspectionInspection
LIGHTING SYSTEM > Back-up Light SystemINSPECTION1. CHECK BACK-UP LIGHT SWITCH (MT MODEL)Refer to “INSPECTION” of the “Switches and Harness” in “MANUAL TRANSMISSION AND DIFFERENTIAL” section. Switches and Harness > INSPECTION">2. CHECK INHIBITOR SWIT ...
Removal
SECURITY AND LOCKS > Keyless Entry Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL">3. Remove the keyless entry control module.(1) Disconnect the connector.(2) Remove the bolt and th ...
Inspection
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Subaru Select MonitorINSPECTION1. COMMUNICATION FOR INITIALIZING IMPOSSIBLEWhen communication with the radar sensor is impossibleDetecting condition:• Defective harness connector• Power supply circuit malfunction• Def ...