Subaru Crosstrek Owners Manual: Viewing range on the screen
CAUTION
The range that can be viewed with the rear view camera is limited.
Always be sure to check with your eyes when moving backward and proceed slowly.
Range of view
Range of view
Image from camera
The area from the rear end of the bumper can be viewed. Areas at both ends of the bumper and areas just under the bumper cannot be viewed.
Also, the image from the rear view camera looks shorter than the actual distance.
Range of view
Image from camera
The area above the camera cannot be viewed. If there is an object that has a wide projection on its upper part such as a sign pole behind the vehicle, the projection cannot be seen on the screen.
How to use the rear view camera
When the shift lever/select lever is set to
"R", the rear view camera automatically
displays the rear view image from the
vehicle. When the lever is set to other
positions, the image before settin ...
Help line
The help line (distance marker and vehicle
width line) is a guide to help you realize
the actual distance from the screen image.
1) Vehicle width line (oblique vertical line)
2) Approx. 10 feet ...
Other materials:
Inspection
VEHICLE DYNAMICS CONTROL (VDC) > Rear ABS Wheel Speed SensorINSPECTION1. CHECK WITH SUBARU SELECT MONITOR1. Connect the Subaru Select Monitor.NOTE:For detailed operation procedures, refer to “Application help”.(1) On «Start» display, select «Diagnosis».(2) On «Vehicle selection» ...
Installation
FRONT SUSPENSION > Front ArmINSTALLATION1. Before installation, inspect the following items and replace any faulty part with a new one.• Check the front arm assembly for damage or cracks, and replace if defective.• Visually check the bushing for abnormal cracks, fatigue or damage.&bul ...
Dtc p0138 o2 sensor circuit high voltage bank 1 sensor 2
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0138 O2 SENSOR CIRCUIT HIGH VOLTAGE BANK 1 SENSOR 2DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory ...
