Subaru Crosstrek Owners Manual: How to use the rear view camera
When the shift lever/select lever is set to "R", the rear view camera automatically displays the rear view image from the vehicle. When the lever is set to other positions, the image before setting to "R" is displayed.
1. Set the ignition switch to "ON".
2. Set the shift lever/select lever to "R".
NOTE
For models with the genuine SUBARU navigation system or audio system, while the navigation system is activated, the image of the rear view camera will not be displayed. However, the image of the rear view camera has priority over other screen displays.
The image of the rear view camera is horizontally reversed as is the case with the vehicle rearview mirror or the side view mirror.
It may be difficult to see the rear view camera image in the following cases. This is not a malfunction of the camera.
- The vehicle is used for towing or a trailer hitch is installed.
- The vehicle is in a dark place (at night, in a tunnel, etc.).
- The vehicle is in an extremely hot or cold place.
- An object (such as raindrops, snow, dirt, etc.) that disturbs the view of the rear view camera sticks to the lens of the camera.
- Strong light shined directly on the camera lens (occasionally, there are vertical lines on the screen).
Rear view camera
A rear view camera is attached to the rear
gate. When the ignition switch is "ON" and
the shift lever (MT models) or select lever
(CVT models) is set to "R", the rear view
camera automatically ...
Viewing range on the screen
CAUTION
The range that can be viewed with
the rear view camera is limited.
Always be sure to check with your
eyes when moving backward and
proceed slowly.
Range of view
Range of view
...
Other materials:
Rear towing hook
1. Take the towing hook and screwdriver
out of the tool bucket. Take the jack
handle out of the cargo area.
2. Pry off the cover on the rear bumper
using a screwdriver, and you will find a
threaded hole for attaching the towing
hook.
3. Screw the towing hook into the thread
hole unti ...
List
AUTO HEADLIGHT BEAM LEVELER SYSTEM (DIAGNOSTICS) > Read Current DataLISTItem NameContentStandardNoteTrip Count [count]Time stamp information, trip counter — — CountTime stamp information, original counter identification information — — Time Count [msec]Time stamp information, time count ...
List
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Read Current DataLIST• «Subaru Rear Vehicle Detection (LH)»DisplayContentReference valueNoteSRVD System fail flagCurrent failure status of BSD/RCTA system is displayed.• Normal• Fail — SRVD System HALT flagCurrent ...
