Subaru Crosstrek Owners Manual: Preparation
1. Turn off the ignition switch.
2. Close all doors (including rear gate).
3. Press and hold the "
"
button on the
access key. All doors (including rear gate)
will then be locked.
4. Keep the "
" button
pressed, and
press the rear lock button within 5
seconds after step 3.
5. Press and hold the above button for more than 5 seconds. Then a chirp will sound.
6. Release the "
" button and rear
lock
button.
7. Press the " 
" button on the
access key
while the chirp sounds.
Then the chirp will stop and the preparation is complete.
NOTE
If you do not press the " "
button on
the access key, the chirp will sound for
30 seconds. In this case, the preparation
for registering a PIN code does not
complete even if the chirp stops.
Registration
For example, to register "32468" as the
PIN code, perform the following procedure.
1. Press the rear lock button three times.
2. After a buzzer (ding) sounds once,
press the rear lock button t ...
Other materials:
Caution
INTAKE (INDUCTION)(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.2. Protect the vehicle using a seat cover, ...
Assembly
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Leak Check Valve AssemblyASSEMBLY1. Install the bracket to the leak check valve assembly.Tightening torque:18 N·m (1.8 kgf-m, 13.3 ft-lb)2. Install the drain tube to the leak check valve assembly.CAUTION:• Check that there is n ...
Electrical specification
INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD) SystemELECTRICAL SPECIFICATION1. MULTI FUNCTION DISPLAY• Standard typeTerminal No.ItemMeasuring conditionStandard1 (+B) ←> Chassis groundVoltageAlways10 — 14 V2 (GND) ←> Chassis groundResistanceAlwaysLess than 1 ?3 ...
