Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Registration

For example, to register "32468" as the PIN code, perform the following procedure.

1. Press the rear lock button three times.

2. After a buzzer (ding) sounds once, press the rear lock button twice.

3. After a buzzer (ding) sounds once, press the rear lock button four times.

4. After a buzzer (ding) sounds once, press the rear lock button six times.

5. After a buzzer (ding) sounds once, press the rear lock button eight times.

6. Perform steps 1 to 5 again within approximately 30 seconds after the buzzer starts sounding intermittently.

7. All doors (including rear gate) will be unlocked and locked. Then the PIN code will be registered.

NOTE

When you try to register "22222", the registered PIN code will be deleted.

You cannot unlock the doors by PIN Code Access until a new code is registered.

After registering a new PIN code, make sure that you can unlock the doors using the PIN code.

The PIN code cannot be deleted while the keyless access function is disabled by operating the access key.

Reregister the PIN code in the following case.

Preparation
1. Turn off the ignition switch. 2. Close all doors (including rear gate). 3. Press and hold the "  " button on the access key. All doors (including rear gate) will then be locked. 4 ...

Unlocking
Perform steps 1 to 5 described in "Registration". NOTE You cannot unlock by PIN Code Access in the following cases. when the access key is within the operating ranges when the ignition swit ...

Other materials:

Clear memory mode Operation
IMMOBILIZER (DIAGNOSTICS) > Clear Memory ModeOPERATIONNOTE:For detailed operation procedures, refer to “Application help”.1. ECM1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main ...

Inspection
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > General DescriptionINSPECTIONBefore performing diagnosis, check the following item which might affect the quality of the tire pressure monitoring system.1. TIRE• Inspect that the tire pressure is within the specification while the tire is cool ...

Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Center DifferentialINSTALLATION1. Attach the center differential to transfer case.2. Install the transfer driven gear. Transfer Driven Gear > INSTALLATION">3. Install the transfer case together with the extension case assembly. Transfer Cas ...

© 2016-2025 Copyright www.sucross.com