Subaru Crosstrek Owners Manual: Unlocking
Perform steps 1 to 5 described in "Registration".
NOTE
You cannot unlock by PIN Code Access in the following cases.
- when the access key is within the operating ranges
- when the ignition switch is in the "ACC" or "ON" position
If you make an operation error during the unlocking procedure, start over with the unlocking procedure after waiting for 5 seconds or longer
To protect your vehicle from theft, a buzzer will sound if incorrect PIN codes are entered five times continuously. If this occurs, you cannot unlock the doors by PIN Code Access for 5 minutes.
Registration
For example, to register "32468" as the
PIN code, perform the following procedure.
1. Press the rear lock button three times.
2. After a buzzer (ding) sounds once,
press the rear lock button t ...
Remote keyless entry system
CAUTION
Do not expose the remote transmitter
to severe shocks, such as
those experienced as a result of
dropping or throwing.
Do not take the remote transmitter
apart except when replaci ...
Other materials:
Installation
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Primary Speed SensorINSTALLATIONCAUTION:Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part.Install in the reverse order of removal.NOTE:• Use new O-rings.&bul ...
To arm the system using access
key/remote transmitter
1. Close all windows and the moonroof (if
equipped).
2. Remove the key from the ignition
switch (models without "keyless access
with push-button start system")/turn the
push-button ignition switch to the "OFF"
position (models with "keyless access with
push-button start system").
3. Open ...
Refrigerant leak check Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Refrigerant Leak CheckINSPECTION1. Attach the manifold gauge set.Preparation tool:Manifold gauge set(1) Check that all valves are fully closed.(2) Install the low/high pressure hoses to the service ports on the low/high pressure sides of the vehicle resp ...
