Subaru Crosstrek Service Manual: Connecting rod Specification
MECHANICAL(H4DO) > Connecting Rod
SPECIFICATION
Refer to “Cylinder Block” for removal and installation procedures of connecting rod.
Cylinder Block > REMOVAL">
Cylinder Block > INSTALLATION">
Compression Inspection
MECHANICAL(H4DO) > CompressionINSPECTIONCAUTION:After warming-up, engine becomes very hot. Be careful not to burn yourself during measurement.1. Turn the ignition switch to OFF.2. After warming-up ...
Crankshaft Specification
MECHANICAL(H4DO) > CrankshaftSPECIFICATIONRefer to “Cylinder Block” for removal and installation procedures of the crankshaft. Cylinder Block > REMOVAL"> Cylinder Block > ...
Other materials:
Preparing to drive
You should perform the following checks
and adjustments every day before you
start driving.
1. Check that all windows, mirrors, and
lights are clean and unobstructed.
2. Check the appearance and condition
of the tires. Also check tires for proper
inflation.
3. Look under the vehicle fo ...
Removal
EXTERIOR/INTERIOR TRIM > Floor MatREMOVALCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Airbag system satellite safing sensor is lo ...
Installation
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Reverse Check SleeveINSTALLATION1. Install the reverse check sleeve.Tightening torque:6.4 N·m (0.7 kgf-m, 4.7 ft-lb)2. Install the reverse check ball, reverse accent spring, gasket and plug.NOTE:Use a new gasket.Tightening torque:9.75 N·m ...
