Subaru Crosstrek Service Manual: Removal
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Inhibitor Switch
REMOVAL
1. Shift the select lever to “N” range.
2. Disconnect the ground cable from battery. NOTE">
NOTE:
For model with battery sensor, disconnect the ground terminal from battery sensor.
3. Lift up the vehicle.
4. Remove the center exhaust pipe. Center Exhaust Pipe > REMOVAL">
5. Remove the snap pin and washer from the shifter arm.
CAUTION:
Do not apply extra overload while holding the part (A).
(A) | Shifter arm |
(B) | Snap pin |
(C) | Select cable |
(D) | Washer |
6. Remove the spring pin and shifter arm.
(A) | Spring pin |
(B) | Shifter arm |
7. Remove the inhibitor harness connector from inhibitor switch.
8. Remove the two inhibitor switch securing bolts.
9. Remove the inhibitor switch from the transmission case.
Adjustment
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Inhibitor SwitchADJUSTMENT1. Shift the select lever to “N” range.2. Loosen the two bolts holding the inhibitor switch.3. Insert the ST vertic ...
Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Inhibitor SwitchINSPECTIONWhen the driving condition or starter motor operation is improper, first check the shift linkage for improper operation. If the ...
Other materials:
Removal
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > Air Mix Door ActuatorREMOVAL1. LHCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground ...
Keyless access system Wiring diagram
WIRING SYSTEM > Keyless Access SystemWIRING DIAGRAM ...
Maintenance
Carry some emergency equipment, such
as a window scraper, a bag of sand,
flares, a small shovel and jumper cables.
Check the battery and cables. Cold
temperatures reduce battery capacity.
The battery must be in good condition to
provide enough power for cold winter
starts.
It normally ...
