Subaru Crosstrek Service Manual: Installation
SECURITY AND LOCKS > Starter Cut Relay
INSTALLATION
CAUTION:
Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">
Install each part in the reverse order of removal.
Tightening torque:
Relay & fuse box: 7.5 N·m (0.76 kgf-m, 5.5 ft-lb)
Removal
SECURITY AND LOCKS > Starter Cut RelayREMOVALCAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM” ...
Other materials:
Removal
LIGHTING SYSTEM > Rear Turn Signal Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear com ...
Installation
DRIVE SHAFT SYSTEM > Front Drive ShaftINSTALLATION1. Before installation, check the drive shaft assembly. Front Drive Shaft > INSPECTION">2. Replace the differential side retainer oil seal with a new part.• MT model: Differential Side Retainer Oil Seal > REPLACEMENT"> ...
Dtc p2097 post catalyst fuel trim system too rich bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2097 POST CATALYST FUEL TRIM SYSTEM TOO RICH BANK 1DTC detecting condition:Detected when two consecutive driving cycles with fault occur.CAUTION:After servicing or replacing faulty parts, perform Clear Memory ...
