Subaru Crosstrek Service Manual: Read diagnostic trouble code (dtc) Operation
IMMOBILIZER (DIAGNOSTICS) > Read Diagnostic Trouble Code (DTC)
OPERATION
NOTE:
• For detailed operation procedures, refer to “Application help”.
• For details concerning DTC, refer to List of Diagnostic Trouble Code (DTC). List of Diagnostic Trouble Code (DTC)">
1. ECM
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Engine Control System» and then select «Enter».
5. On «Engine Control System» display, select «DTC».
2. BODY INTEGRATED UNIT
1. On «Start» display, select «Diagnosis».
2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».
3. On «Main Menu» display, select «Each System».
4. On «Select System» display, select «Body Control» and then select «Enter».
5. On «Body Control» display, select «DTC».
List of diagnostic trouble code (dtc) List
IMMOBILIZER (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LISTNOTE:If DTCs irrelevant to the immobilizer are detected, perform diagnosis according to the DTCs irrelevant to the immobilizer f ...
Subaru select monitor Operation
IMMOBILIZER (DIAGNOSTICS) > Subaru Select MonitorOPERATION1. HOW TO USE THE SUBARU SELECT MONITORFor detailed operation procedures, refer to “Application help”.2. READ DIAGNOSTIC TROUBL ...
Other materials:
Inspection
WIPER AND WASHER SYSTEMS > Wiper and Washer SystemINSPECTIONSymptomsRepair orderWiper and washers do not operate.(1) Wiper fuse (F/B No. 14, 15)(2) Combination switch(3) Motor assembly - wiper(4) Wiring harnessWipers do not operate in LO or HI.(1) Combination switch(2) Motor assembly - wiper(3) W ...
Preparation tool
AIRBAG SYSTEM > General DescriptionPREPARATION TOOL1. SPECIAL TOOL• TEST HARNESS NILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS98299SA000TEST HARNESS NUsed for unit inspection of steering roll connector.• TEST HARNESS QILLUSTRATIONTOOL NUMBERDESCRIPTIONREMARKS98299SA040TEST HARNESS QUsed ...
Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Electronic Throttle Control RelayREMOVAL1. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work.2. Release the lock and remove the fuse holder from the relay & fuse box.3. Disconnect the connectors from the relay ...
