Subaru Crosstrek Service Manual: Immobilizer (diagnostics)
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc b1401 meter collation
- Dtc b1571 reference code incompatibility (immobilizer cm to ecm)
- Dtc b1402 immobilizer key collation
- Dtc b1405 scu collation
- Dtc b1406 scu_eeprom
- Dtc b1407 met communication
- Dtc b1408 meter non-volatile memory
- Dtc b1409 scu communication
- Dtc b1410 transponder communication
- Dtc b1411 immobilizer antenna
- Dtc b1570 antenna
- Dtc b1572 imm circuit except antenna circuit
- Dtc b1574 key communication
- Dtc b1575 incorrect immobilizer key
- Dtc b1576 egi control module eeprom
- Dtc b1577 imm control module eeprom
- Dtc b1578 meter
- General description
- Basic diagnostic procedure Procedure
- Clear memory mode Operation
- Diagnostics chart for security indicator light Inspection
- Electrical component location Location
- Immobilizer control module i/o signal Wiring diagram
- List of diagnostic trouble code (dtc) List
- Read diagnostic trouble code (dtc) Operation
- Subaru select monitor Operation
Installation
IGNITION(H4DO) > Spark PlugINSTALLATION1. RH SIDEInstall in the reverse order of removal.CAUTION:Degrease the ignition coil installation portion and the mounting bolts.Tightening torque:Spark plug1 ...
Other materials:
Dtc c1241 rear left abs sensor circuit
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C1241 REAR LEFT ABS SENSOR CIRCUITDTC detecting condition:• Defective ABS wheel speed sensor (broken wire, input voltage too high)• Defective harness connectorTrouble symptom:&bul ...
Inspection
HVAC SYSTEM (HEATER, VENTILATOR AND A/C) > CompressorINSPECTION1. MAGNET CLUTCH CLEARANCE INSPECTION1. Check the clearance of entire circumference around the drive plate and pulley.Specification:0.3 — 0.6 mm (0.0118 — 0.0236 in)2. Replace the compressor assembly if the inspection result is no ...
Removal
GLASS/WINDOWS/MIRRORS > Rear Door GlassREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear door. Door Trim > REMOVAL">3. Remove the sealing cover - rear door. Rear Sealing Cover > REMOVAL">4. Attach the battery ground cable an ...
