Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Dtc b1577 imm control module eeprom

IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)

DTC B1577 IMM CONTROL MODULE EEPROM

DTC DETECTING CONDITION:

• Body integrated unit malfunctioning

• Failed to access ROM inside the body integrated unit.

CAUTION:

When the body integrated unit is replaced, registration of the immobilizer system is required. For details, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

STEPCHECKYESNO

1.PERFORM ECM REGISTRATION.

Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

Is registration complete?

Finish the diagnosis.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1577 IMM CONTROL MODULE EEPROM">Go to Step 2.

2.PERFORM ECM REGISTRATION.

1) Perform the Clear Memory Mode. (ECM and body integrated unit) Clear Memory Mode">

2) Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

Is registration complete?

Even if DTC is detected, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE:

In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.

Replace the body integrated unit. Body Integrated Unit">

Dtc b1576 egi control module eeprom
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1576 EGI CONTROL MODULE EEPROMDTC DETECTING CONDITION:• ECM malfunctioning• Failed to access ROM ...

Dtc b1578 meter
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1578 METERDTC DETECTING CONDITION:• Except for C5 modelReference code incompatibility between combinati ...

Other materials:

Inspection
LIGHTING SYSTEM > Hazard SwitchINSPECTION1. Measure the resistance between connector terminals.Preparation tool:Circuit testerTerminal No.Inspection conditionsStandard2 — 3Switch OFF1 M? or moreSwitch ONLess than 1 ?2. Apply battery voltage between the connector terminals to check the lighting ...

Installation
AIRBAG SYSTEM > Side Airbag ModuleINSTALLATIONCAUTION:• Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">• Make sure that the side airbag module ...

Electrical component location Location
TELEMATICS SYSTEM (DIAGNOSTICS) > Electrical Component LocationLOCATION(1)Data link connector(4)Data communication module (DCM)(6)Instrument panel speaker(2)GPS antenna(5)Audio or navigation(7)Airbag CM(3)Telematics sub antenna (1)Telematics antenna(2)Door speaker (standard specification) (1) ...

© 2016-2026 Copyright www.sucross.com