Subaru Crosstrek Service Manual: Dtc b1576 egi control module eeprom
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B1576 EGI CONTROL MODULE EEPROM
DTC DETECTING CONDITION:
• ECM malfunctioning
• Failed to access ROM in ECM during key registration.
CAUTION:
When the ECM is replaced, registration of the immobilizer system is required. For details, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
| STEP | CHECK | YES | NO |
1.PERFORM ECM REGISTRATION.
Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
Is registration complete?
Finish the diagnosis.
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1576 EGI CONTROL MODULE EEPROM">Go to Step 2.
2.PERFORM ECM REGISTRATION.
Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
Is registration complete?
Finish the diagnosis.
Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1576 EGI CONTROL MODULE EEPROM">Go to Step 3.
3.PERFORM ECM REGISTRATION.
Perform ECM registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
Is registration complete?
Finish the diagnosis.
Replace the ECM. Engine Control Module (ECM)">
Dtc b1575 incorrect immobilizer key
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1575 INCORRECT IMMOBILIZER KEYDTC DETECTING CONDITION:Incorrect immobilizer key (use of unregistered key in b ...
Dtc b1577 imm control module eeprom
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1577 IMM CONTROL MODULE EEPROMDTC DETECTING CONDITION:• Body integrated unit malfunctioning• Fail ...
Other materials:
Relay and fuse
Inspection
CRUISE CONTROL SYSTEM > Relay and FuseINSPECTION1. CHECK FUSE1. Remove the fuse and inspect visually.2. If the fuse is blown out, replace the fuse.NOTE:If the fuse is blown again, check the system wiring harness. Location
CRUISE CONTROL SYSTEM > Relay and FuseLOCATIONRelay & f ...
Assembly
EXTERIOR/INTERIOR TRIM > Door TrimASSEMBLY1. Bend the claws while pushing the weather strip - door INN against the door trim so that there is no gap.CAUTION:Beware of the direction of folding the claws.(a)Rivet(b)Direction of folding claws(c)Claw bending direction: bend forward for LH side, backw ...
Dtc b2329 rear radar axis alignment incomplete
Blind Spot Detection/Rear Cross Traffic Alert (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2329 REAR RADAR AXIS ALIGNMENT INCOMPLETEDTC DETECTING CONDITION:Axis adjustment of the radar sensor has failed.(Forced termination of the Subaru Select Monitor, improper loca ...
