Subaru Crosstrek Service Manual: Installation
IGNITION(H4DO) > Spark Plug
INSTALLATION
1. RH SIDE
Install in the reverse order of removal.
CAUTION:
Degrease the ignition coil installation portion and the mounting bolts.
Tightening torque:
Spark plug
17.5 N·m (1.8 kgf-m, 12.9 ft-lb)
Ignition coil
8.5 N·m (0.9 kgf-m, 6.3 ft-lb)
2. LH SIDE
Install in the reverse order of removal.
CAUTION:
Degrease the ignition coil installation portion and the mounting bolts.
Tightening torque:
Spark plug
17.5 N·m (1.8 kgf-m, 12.9 ft-lb)
Ignition coil
8.5 N·m (0.9 kgf-m, 6.3 ft-lb)
Removal
IGNITION(H4DO) > Spark PlugREMOVALSpark plug:Refer to “SPECIFICATION” for spark plug. General Description > SPECIFICATION">1. RH SIDE1. Disconnect the ground cable from batt ...
Other materials:
Drain filter Specification
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > Drain FilterSPECIFICATIONThe leak check valve assembly is a non-disassembled part. Do not remove the drain filter from the leak check valve assembly. Refer to “Leak Check Valve Assembly” for removal and installation procedures. ...
Trailer brakes
WARNING
Adequate size trailer brakes are
required when the trailer and its
cargo exceed 1,000 lbs (453 kg)
total weight.
Do not directly connect your
trailer's hydraulic brake system
to the hydraulic brake system in
your vehicle. Direct connection
would cause the vehicle's brake
...
Removal
EXTERIOR BODY PANELS > Front FenderREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the bumper face - front. Front Bumper > REMOVAL">3. Remove the light assembly - head. Headlight Assembly > REMOVAL">4. Remove the cover - front fender.(1) Remove ...
