Subaru Crosstrek Service Manual: Dtc b1406 scu_eeprom
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)
DTC B1406 SCU_EEPROM
DTC DETECTING CONDITION:
• Defective security control module
• ROM of security control module cannot be accessed
CAUTION:
When the security control module is replaced, registration of the immobilizer system is required. For details, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
| STEP | CHECK | YES | NO |
1.PERFORM SECURITY CONTROL MODULE REGISTRATION.
1) Perform security control module registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.
2) Perform the Clear Memory Mode. Clear Memory Mode">
3) Read the DTC of the body integrated unit. Read Diagnostic Trouble Code (DTC)">
Is DTC B1406 detected?
Replace the security control module. Security Control Module">
Finish the diagnosis.
Dtc b1405 scu collation
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1405 SCU COLLATIONDTC DETECTING CONDITION:Reference code incompatibility between security control module and ...
Dtc b1407 met communication
IMMOBILIZER (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B1407 MET COMMUNICATIONDTC DETECTING CONDITION:Communication failure between body integrated unit and combinat ...
Other materials:
Sound settings
Touch the tab to set the
sound quality.
Item
Function
Balance/
Fader
Select to adjust speaker volume
balance (right/left and front/rear).
Speed Volume
Control
Select to adjust speaker volume
coupled to vehicle speed.
Graphic
Equa ...
Dtc u0073 control module communication bus off
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0073 CONTROL MODULE COMMUNICATION BUS OFFDetected when CAN line abnormality is detected.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedure > PROCEDURE&qu ...
Operation
INSTRUMENTATION/DRIVER INFO > Multi-function Display (MFD) SystemOPERATION1. DIAGNOSTIC MODE (HIGH GRADE TYPE ONLY)The settings of the multi-function display can be changed by performing the following procedures to display the diagnostic mode. To show the demonstration display only, refer to &ldq ...
