Subaru Crosstrek Service Manual: Dtc b1405 scu collation

DTC DETECTING CONDITION:

Reference code incompatibility between security control module and body integrated unit

CAUTION:

When the security control module is replaced, registration of the immobilizer system is required. For details, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

1.CHECK DTC.

Read the DTC of the body integrated unit. Read Diagnostic Trouble Code (DTC)">

Is any of DTC B1406 or B1409 detected?

Perform the diagnosis according to DTC.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1405 SCU COLLATION">Go to Step 2.

2.PERFORM SECURITY CONTROL MODULE REGISTRATION.

Perform security control module registration. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

Is registration complete?

Currently, it is normal. (Security control module registration is not complete.)

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1405 SCU COLLATION">Go to Step 3.

3.CHECK DTC.

1) Perform the Clear Memory Mode. Clear Memory Mode">

2) Read the DTC of the body integrated unit. Read Diagnostic Trouble Code (DTC)">

Is any of DTC B1406 or B1409 detected?

Perform the diagnosis according to DTC.

Replace the security control module. Security Control Module">

Dtc b1402 immobilizer key collation

Dtc b1406 scu_eeprom

Other materials:

Inspection
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > PCV ValveINSPECTION1. PCV VALVE1. Check that the PCV valve has no deformation, cracks or other damages.2. Check that air is discharged from (B) when air is blown into (A).3. Check that air does not come out from (B) when air is blown into ( ...

Dtc p0117 engine coolant temperature sensor 1 circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0117 ENGINE COOLANT TEMPERATURE SENSOR 1 CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Hard to start• Improper idling• Poor driving performanceCAUTION: ...

Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyADJUSTMENTSelection of main shaft rear plate:Measure the protrusion amount (A) of ball bearing from transmission main case surface, and select a suitable plate in the following table.NOTE:Before measuring, tap the end of main shaft wi ...