Subaru Crosstrek Service Manual: Dtc b1401 meter collation

DTC DETECTING CONDITION:

Reference code incompatibility between combination meter and body integrated unit

CAUTION:

When the combination meter is replaced, registration of the immobilizer system is required. For details, refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

1.CHECK DTC.

Read the DTC of the body integrated unit. Read Diagnostic Trouble Code (DTC)">

Is any of DTC B1407 or B1408 detected?

Perform the diagnosis according to the DTC.

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1401 METER COLLATION">Go to Step 2.

2.CHECK COMBINATION METER REGISTRATION.

Perform registration of combination meter. Refer to the “REGISTRATION MANUAL FOR IMMOBILIZER” provided as a separate volume.

Is registration complete?

Currently, it is normal. (Combination meter registration is not complete.)

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC B1401 METER COLLATION">Go to Step 3.

3.CHECK DTC.

1) Perform the Clear Memory Mode. Clear Memory Mode">

2) Read the DTC of the body integrated unit. Read Diagnostic Trouble Code (DTC)">

Is any of DTC B1407 or B1408 detected?

Perform the diagnosis according to the DTC.

Replace the combination meter. Combination Meter">

Diagnostic procedure with diagnostic trouble code (dtc)

Dtc b1571 reference code incompatibility (immobilizer cm to ecm)

Other materials:

Dtc p0336 crankshaft position sensor "a" circuit range/performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0336 CRANKSHAFT POSITION SENSOR "A" CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine stall• Failure ...

Installation
CLUTCH SYSTEM > FlywheelINSTALLATION1. Press in a new pilot bearing to the position where it is flush with the flywheel surface or up to 0.4 mm (0.016 in) deeper than that.CAUTION:Do not press the bearing inner ring.(A)Pilot bearing2. Temporarily tighten the crankshaft position sensor plate and f ...

Component
ENTERTAINMENT > General DescriptionCOMPONENT1. DATA COMMUNICATION MODULE(1)Cap screw(4)Backup batteryTightening torque: N·m (kgf-m, ft-lb)(2)Backup battery cover(5)Data communication moduleT:0.3 (0.03, 0.2)(3)Circlip ...