Subaru Crosstrek Service Manual: Clear memory mode Operation

NOTE:

For detailed operation procedures, refer to “Application help”.

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Engine Control System» and then select «Enter».

5. On «Engine Control System» display, select «DTC».

6. On «DTC» display, select «Clear Memory».

NOTE:

Initial diagnosis of electronic throttle control is performed after memory clearance. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.

1. On «Start» display, select «Diagnosis».

2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».

3. On «Main Menu» display, select «Each System».

4. On «Select System» display, select «Body Control» and then select «Enter».

5. On «Body Control» display, select «DTC».

6. On «DTC» display, select «Clear Memory».

Basic diagnostic procedure Procedure

Diagnostics chart for security indicator light Inspection

Other materials:

List of diagnostic trouble code (dtc) List
IMMOBILIZER (DIAGNOSTICS) > List of Diagnostic Trouble Code (DTC)LISTNOTE:If DTCs irrelevant to the immobilizer are detected, perform diagnosis according to the DTCs irrelevant to the immobilizer first.1. ECMDTCItemContents of diagnosisIndex No.B1570ANTENNAFaulty antenna Diagnostic Procedure with ...

Replacement
DIFFERENTIALS > Differential Gear OilREPLACEMENTCAUTION:• Gear oil is extremely hot just after driving. Be wary of receiving burns.• Be careful not to spill the differential gear oil on exhaust pipe. If gear oil is spilled, wipe it off completely.1. Lift up the vehicle.2. Remove the d ...

Handling of radar sensors
Radar sensors The radar sensors, one on each side of the vehicle, are mounted inside the rear bumper. CAUTION To ensure correct operation of the BSD/RCTA, observe the following precautions. Always keep the bumper surface near the radar sensors clean Do not affix any stickers o ...