Subaru Crosstrek Owners Manual: Basic operation
By operating "
" or "
" of the control
switch, the screens and selection items
can be switched. When the "
/SET"
switch is pulled toward you, the item can
be selected and set.
If there are some useful messages, such as vehicle information, warning information, etc., they will interrupt the current screen, and appear on the display accompanied by a beep. If such a screen is displayed, take proper action according to the message shown on the screen.
The warning screen will return to the
original screen after a few seconds. While
the "
" information reminder is shown on
the display, it may be possible to display
the warning screen again. To recall the
message marked with "
" on the display,
pull the "
/SET" switch on the steering
wheel toward you.
Multi information display (models with type B combination meter)
WARNING
Always pay adequate attention to
safe driving when operating the
multi information display while the
vehicle is in motion. When operation
of the multi information display
interferes with ...
Welcome screen and Good-bye screen
When the driver's door is opened and
closed after unlocking the door, the
welcome screen will appear on the multi
information display for approximately 20
seconds.
When the ignition switch is t ...
Other materials:
Dtc c0051 valve relay
VEHICLE DYNAMICS CONTROL (VDC) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C0051 VALVE RELAYDTC detecting condition:Defective valve relayTrouble symptom:• ABS does not operate.• EBD does not operate.• VDC does not operate.• EyeSight does not ...
Clock
In the Subaru Ascent, vehicles equipped with a genuine SUBARU navigation and/or
audio system allow the clock to be configured either automatically or manually,
depending on driver preference and system capabilities.
Setting the clock manually
1. Turn the ignition switch to the "ON" p ...
Dtc b14e5 mode door actuator stepping motor circuit open
HVAC SYSTEM (AUTO A/C) (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B14E5 MODE DOOR ACTUATOR STEPPING MOTOR CIRCUIT OPENDTC detecting condition:Mode door actuator stepping motor circuit is open.Trouble symptom:Vent does not change.Wiring diagram:Air conditioning syst ...
