Subaru Crosstrek Owners Manual: Welcome screen and Good-bye screen
When the driver's door is opened and closed after unlocking the door, the welcome screen will appear on the multi information display for approximately 20 seconds.
When the ignition switch is turned to the "LOCK"/"OFF" position, the multi information display gradually turns off (Good-bye screen).
NOTE
- The basic screen will be shown when the ignition switch is turned to the "ON" position while the welcome screen is displayed.
- Once the welcome screen appears, it takes a certain period of time to display it again.
- If the ignition switch is operated after unlocking the driver's door, the welcome screen will not appear even when the driver's door is opened and closed.
- The welcome screen will disappear when you lock the driver's door by using the remote keyless entry system (all models) or the keyless access function (if equipped) while the welcome screen is displayed.
- If any of the doors (including the rear gate) is opened while the welcome screen is displayed, the door ajar warning will appear.
- The welcome screen can be set to on or off. For details, refer to "Welcome Good-bye Screen"
Basic operation
By operating "
" or "
" of the control
switch, the screens and selection items
can be switched. When the "
/SET"
switch is pulled toward you, the item can
be selected and set.
...
Warning screen
Example of warning
If there is a warning message or a
maintenance notification, it will appear for
approximately 3 seconds. Take the appropriate
actions based on the messages
indicated. ...
Other materials:
Reporting safety defects (U.S.A.)
If you believe that your vehicle has
a defect which could cause a
crash or could cause injury or
death, you should immediately inform
the National Highway Traffic
Safety Administration (NHTSA) in
addition to notifying Subaru of
America, Inc.
If NHTSA receives similar complaints,
it may op ...
Illumination brightness control
The illumination brightness of the instrument
panel dims under the following
conditions.
when the light switch is in the "
" or
" " position
You can also adjust the illumination brightness
for better visibility in the following
ways.
To brighten, turn the control dial upward.
...
Removal
EXTERIOR/INTERIOR TRIM > Roof RailREMOVAL1. Remove the trim panel - roof. Roof Trim > REMOVAL">2. Remove the curtain airbag module. Curtain Airbag Module > REMOVAL">CAUTION:• Before handling the airbag system components, refer to “CAUTION” of “Gener ...
