Subaru Crosstrek Service Manual: Installation

1. Install the oil pump. Oil Pump > INSTALLATION">

2. Install the oil pump chain cover. Oil Pump Chain > INSTALLATION">

3. Install the front differential assembly. Front Differential Assembly > INSTALLATION">

4. Install the drive pinion shaft assembly. Drive Pinion Shaft Assembly > INSTALLATION">

5. Install the forward clutch assembly. Forward Clutch Assembly > INSTALLATION">

6. Install the reverse brake assembly. Reverse Brake Assembly > INSTALLATION">

7. Install the primary pulley, secondary pulley and variator chain. Primary Pulley and Secondary Pulley > INSTALLATION">

8. Install the reduction drive gear. Reduction Drive Gear > INSTALLATION">

9. Install the transmission case. Transmission Case > INSTALLATION">

10. Install the transmission control device. Transmission Control Device > INSTALLATION">

11. Install the oil strainer and oil pan. Oil Pan and Strainer > INSTALLATION">

12. Install the reduction driven gear assembly. Reduction Driven Gear > INSTALLATION">

13. Install the transfer driven gear assembly. Transfer Driven Gear > INSTALLATION">

14. Install the transfer clutch assembly. Transfer Clutch > INSTALLATION">

15. Install the parking pawl. Parking Pawl > INSTALLATION">

16. Install the extension case. Extension Case > INSTALLATION">

17. Install the inhibitor switch. Inhibitor Switch > INSTALLATION">

18. Install the secondary speed sensor. Secondary Speed Sensor > INSTALLATION">

19. Install the primary speed sensor. Primary Speed Sensor > INSTALLATION">

20. Install the turbine speed sensor. Turbine Speed Sensor > INSTALLATION">

21. Install the transmission harness. Transmission Harness > INSTALLATION">

22. Install the control valve body. Control Valve Body > INSTALLATION">

23. Install the air breather hose. Air Breather Hose > INSTALLATION">

24. Install the transmission assembly to the vehicle. Automatic Transmission Assembly > INSTALLATION">

Inspection

Cvtf

Other materials:

Dtc p0365 camshaft position sensor "b" circuit bank 1
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0365 CAMSHAFT POSITION SENSOR "B" CIRCUIT BANK 1DTC DETECTING CONDITION:Immediately at fault recognitionTROUBLE SYMPTOM:• Engine stall• Failure of engine to startCAUTION:After servicing ...

Dtc u0100 lost communication with ecm/pcm a
EyeSight (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U0100 LOST COMMUNICATION WITH ECM/PCM “A”Detected when CAN data from engine control module (ECM) is not transmitted to stereo camera.NOTE:Perform the diagnosis for LAN system. Basic Diagnostic Procedu ...

Component
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > General DescriptionCOMPONENT1. CANISTER, LEAK CHECK VALVE ASSEMBLY AND DRAIN SEPARATORFor structures of the canister, leak check valve assembly and drain separator, refer to “FU (H4DO)”. General Description > COMPONENT" ...