Subaru Crosstrek manuals

Subaru Crosstrek Service Manual: Tire pressure warning light is 25 times blinking and turn on

TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Tire Pressure Warning Light / Trouble Indicator Light Illumination Pattern

TIRE PRESSURE WARNING LIGHT IS 25 TIMES BLINKING AND TURN ON

Detecting condition:

• Defective TPMS & keyless entry CM or TPMS CM

• Defective harness

• Transmitter is faulty.

Trouble symptom:

Every time the engine starts, tire pressure warning light blinks 25 times and then illuminates.

Wiring diagram:

Tire Pressure Monitoring System Tire Pressure Monitoring System > WIRING DIAGRAM">

STEPCHECKYESNO

1.CHECK DTC.

Connect the Subaru Select Monitor, and read the Diagnostic Trouble Code. Read Diagnostic Trouble Code (DTC) > OPERATION">

Is diagnostics code (DTC) displayed?

Perform the diagnosis according to the DTC. List of Diagnostic Trouble Code (DTC)">

Tire Pressure Warning Light / Trouble Indicator Light Illumination Pattern > TIRE PRESSURE WARNING LIGHT IS 25 TIMES BLINKING AND TURN ON">Go to Step 2.

2.CHECK LAN COMMUNICATION.

Inspect LAN system. Basic Diagnostic Procedure > PROCEDURE">

Is there any fault?

Repair it according to the diagnosis for LAN system.

Tire Pressure Warning Light / Trouble Indicator Light Illumination Pattern > TIRE PRESSURE WARNING LIGHT IS 25 TIMES BLINKING AND TURN ON">Go to Step 3.

3.CHECK HARNESS.

Measure the resistance between TPMS & keyless entry CM or TPMS CM and body integrated unit.

Connector & terminal

Without keyless access with push button start

(R221) No. 11 — (i171) No. 11:

With keyless access with push button start

(R211) No. 11 — (i171) No. 11:

Is the resistance less than 10 ??

Tire Pressure Warning Light / Trouble Indicator Light Illumination Pattern > TIRE PRESSURE WARNING LIGHT IS 25 TIMES BLINKING AND TURN ON">Go to Step 4.

Repair the harness.

4.CHECK CONNECTOR.

Check each connector.

Is there poor contact or any other faults?

Repair the connector.

Replace the TPMS & keyless entry CM or TPMS CM. Tire Pressure Monitoring System">

Inspection
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Tire Pressure Warning Light / Trouble Indicator Light Illumination PatternINSPECTION(1)Ignition switch(8)Tire inflation pressure warning light (press ...

Tire pressure warning light does not come on
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Tire Pressure Warning Light / Trouble Indicator Light Illumination PatternTIRE PRESSURE WARNING LIGHT DOES NOT COME ONDETECTING CONDITION:Defective c ...

Other materials:

Keyless buzzer volume setting
1. Perform the preparation steps according to "Preparation for car settings" 2. Operate the "  " or " " switch to select the "Keyless Buzzer Volume" item. Then push the  button. 3. Select a volume level by operating the "  " or "  " switch, and confirm the set ...

Operation
HI - Rapid heating LO - Normal heating Off Left-hand side Right-hand side To turn on the seat heater, push the "LO" or "HI" position on the switch, as desired, depending on the temperature. Selecting the "HI" position will cause the seat to heat up quicker. To turn off ...

Remote engine start system Wiring diagram
WIRING SYSTEM > Remote Engine Start SystemWIRING DIAGRAM ...

© 2016-2026 Copyright www.sucross.com