Subaru Crosstrek Owners Manual: Keyless buzzer volume setting
1. Perform the preparation steps according to "Preparation for car settings"
2. Operate the "
" or "
" switch to
select the "Keyless Buzzer Volume" item.
Then push the
button.
3. Select a volume level by operating the
"
" or "
" switch, and confirm the setting
by pushing the 
button.
4. The system will notify you that the setting is complete.
If the setting is not available, the following notification will be displayed. In this case, perform the setting procedure again.
Preparation for car settings
1. Turn the ignition switch to the "ON"
position.
2. Push and hold the button to
show
the selection screen.
3. After the selection screen is displayed,
operate the " " or "
" switch to ...
Hazard warning flasher setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Hazard Warning Flasher" item.Then push the button.
3. The curr ...
Other materials:
Dtc b2786 steering lock cm communication
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2786 STEERING LOCK CM COMMUNICATIONDTC detecting condition:When communication between keyless access CM and steering lock CM is interrupted for a set amount of time.Trouble sym ...
Before starting out on a trip
Check the towing regulations for trailer
or caravan vehicles that vary by state/
region. Failure to comply with the procedures
set forth will not only compromise
your safety, but will also negate your
insurance coverage and/or may violate
the state road and traffic acts and regulation ...
Dtc u1120 lost communication with autostart stop control module
LAN SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC U1120 LOST COMMUNICATION WITH AUTOSTART STOP CONTROL MODULENOTE:The electric power steering CM identifies whether the Auto Start Stop function is provided or not using information from the combination meter. The ...
