Subaru Crosstrek Owners Manual: Car settings
The items in the car settings can be set.
To change the items, operate the "
" or
" 
" switch, and then push the
button.
- Preparation for car settings
- Keyless buzzer volume setting
- Hazard warning flasher setting
- Defogger setting
- Interior light off delay timer setting
- Auto light sensor sensitivity setting
- Keyless access setting (models with "keyless access with pushbutton start system")
Driving history registration
The items in the driving history can be
registered. To change the items, operate
the " " or "
" switch, and then push the
button.
1. Turn the ignition switch to the "ON"
position.
...
Preparation for car settings
1. Turn the ignition switch to the "ON"
position.
2. Push and hold the button to
show
the selection screen.
3. After the selection screen is displayed,
operate the " " or "
" switch to ...
Other materials:
Adjustment
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Main Shaft AssemblyADJUSTMENTSelection of main shaft rear plate:Measure the protrusion amount (A) of ball bearing from transmission main case surface, and select a suitable plate in the following table.NOTE:Before measuring, tap the end of main shaft wi ...
Installation
MECHANICAL(H4DO) > Cylinder HeadINSTALLATION1. CYLINDER HEAD RH1. Clean the bolt holes in the cylinder block RH.CAUTION:To avoid erroneous tightening of the bolts, clean out the bolt holes sufficiently by blowing with compressed air to eliminate engine coolant etc.2. Apply liquid gasket to both s ...
Dtc b2a0d airbag signal
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A0D AIRBAG SIGNALDiagnosis start condition:When ignition switch is ON.DTC detecting condition:Either the regular signal or collision signal cannot be detected from the airbag CM for at least 30 seconds. ...
