Subaru Crosstrek Owners Manual: Hazard warning flasher setting
1. Perform the preparation steps according to "Preparation for car settings"
2. Operate the " 
" or "
" switch to
select the "Hazard Warning Flasher" item.Then push the button.
3. The current setting will be displayed.
Push the 
button to enter the
selection
mode.
4. Select "On" or "Off" by operating the
" " or "
" switch. Then push the 
button.
5. Select "Set" by operating the "
"
switch, and confirm the setting by pushing
the 
button.
6. The system will notify you that the setting is complete.
If the setting is not available, the following notification will be displayed. In this case, perform the setting procedure again.
Keyless buzzer volume setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Keyless Buzzer Volume" item.
Then push the button.
...
Defogger setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Defogger" item. Then push the
button.
3. The curren ...
Other materials:
Removal
SECURITY AND LOCKS > Keyless Entry Control ModuleREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear apron LH. Rear Quarter Trim > REMOVAL">3. Remove the keyless entry control module.(1) Disconnect the connector.(2) Remove the bolt and th ...
Operation
INSTRUMENTATION/DRIVER INFO (DIAGNOSTICS) > Read Current DataOPERATION1. COMBINATION METER1. On «Start» display, select «Diagnosis».2. On «Vehicle selection» display, input the target vehicle information and select «Confirmed».3. On «Main Menu» display, select «Each System».4. On «Se ...
Caution
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > General DescriptionCAUTIONAirbag system wiring harness is routed near the cruise control command switch.CAUTION:• Do not use the electrical test equipment on the airbag system wiring harnesses and connector circuits.• Be careful not to damage the ...
