Subaru Crosstrek Owners Manual: Preparation for car settings
1. Turn the ignition switch to the "ON" position.
2. Push and hold the 
button to
show
the selection screen.
3. After the selection screen is displayed,
operate the " 
" or "
" switch to show the
"Car Setting" item. Then, push the 
button.
Car settings
The items in the car settings can be set.
To change the items, operate the "
" or
" " switch, and then push the
button. ...
Keyless buzzer volume setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Keyless Buzzer Volume" item.
Then push the button.
...
Other materials:
Installation
STARTING/CHARGING SYSTEMS(H4DO) > BatteryINSTALLATIONCAUTION:After the battery is installed, initial diagnosis of the electronic throttle control is performed. Wait for 10 seconds or more after turning the ignition switch to ON, and then start the engine.1. Install the battery.2. Set the battery ...
Removal
INTAKE (INDUCTION)(H4DO) > Air Intake BootREMOVAL1. Remove the clip (A) from the air intake boot.2. Loosen the clamp (B) securing the air cleaner case (rear) to the air intake boot.3. Loosen the clamp (C) which secures the throttle body to the air intake boot.4. Disconnect the PCV hose and remove ...
Dtc b2283 vehicle speed sensor
KEYLESS ACCESS WITH PUSH BUTTON START SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2283 VEHICLE SPEED SENSORDTC detecting condition:Either of the following malfunctions is detected. (Vehicle speed sensor failure is detected.)• Vehicle speed signal failu ...
