Subaru Crosstrek Owners Manual: Type B
1. Turn the airflow mode selection dial and fan speed control dial to the "AUTO" position.
2. Set the preferred temperature using the temperature control dial.
NOTE
- Each function can be individually
set to the AUTO mode independently of
the other functions. Any function set to
the AUTO mode is controlled automatically.
Any function not set to the AUTO mode can be manually adjusted as desired
- The controllable temperature range may vary depending on the regional specifications of the vehicle.
To turn off the climate control system, turn the fan speed control dial to the "OFF" position. Then the air inlet selection will be set as follows.
- when the AUTO mode is selected: OFF (outside air)
- when the AUTO mode is not selected: the mode that was selected when turning off the climate system will be selected.
Automatic climate control operation (type B, C and D)
When this mode is selected, the fan
speed, airflow distribution, air-inlet control,
and air conditioner compressor operation
are automatically controlled. To activate
this mode, perform the follow ...
Type C and D
1. Depress the "AUTO" button. The
indicator light "FULL AUTO" on the display
illuminates.
2. Set the preferred temperature using
the temperature control dial.
NOTE
The controllable temperat ...
Other materials:
Removal
CLUTCH SYSTEM > Release Bearing and LeverREMOVAL1. Remove the transmission assembly from the vehicle. Manual Transmission Assembly > REMOVAL">2. Remove the two clips from the release lever and remove the release bearing.CAUTION:Be careful not to deform the clips.3. Remove the dust cove ...
43
CRUISE CONTROL SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Cancel Code43• The situation that some or all functions for ABS/VDC can not work is detected.During cruise driving or cruise setting, the situation that some or all functions for ABS/VDC can not work is detected. Basic Diagnost ...
Dtc p2530 ignition switch run position circuit
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P2530 IGNITION SWITCH RUN POSITION CIRCUITDTC detecting condition:Immediately at fault recognitionTrouble symptom:Improper idlingCAUTION:After servicing or replacing faulty parts, perform Clear Memory Mode Cl ...
