Subaru Crosstrek Owners Manual: Type C and D

Subaru Crosstrek Owners Manual / Climate control / Automatic climate control operation (type B, C and D) / Type C and D

1. Depress the "AUTO" button. The indicator light "FULL AUTO" on the display illuminates.

2. Set the preferred temperature using the temperature control dial.

NOTE

The controllable temperature range may vary depending on the regional specifications of the vehicle.
If you operate any of the buttons on the control panel other than the "OFF" button, rear window defogger button and temperature control dial(s) during FULL AUTO mode operation, the "FULL" indicator light on the control panel will turn off and the "AUTO" indicator light will remain illuminated.
You can then manually control the system as desired using the button you operated. To change the system back to the FULL AUTO mode, press the "AUTO" button.

To turn off the climate control system, press the "OFF" button. Then the air inlet selection will be set to OFF (outside air).

Operation tips

Operate the automatic climate control system when the engine is running.
Even when cooling is not necessary, the air conditioner compressor will automatically turn on if the temperature is set much lower than the current outlet air temperature. Even in this case, the "A/C" indicator light on the control panel illuminates.

Type B

1. Turn the airflow mode selection dial and fan speed control dial to the "AUTO" position. 2. Set the preferred temperature using the temperature control dial. NOTE Each function can be ind ...

Sensors

Interior air temperature sensor Solar sensor The automatic climate control system employs several sensors. These sensors are delicate. If they are not treated properly and become damage ...

Other materials:

Dtc p0841 transmission fluid pressure sensor/switch "a" circuit range/performance
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0841 TRANSMISSION FLUID PRESSURE SENSOR/SWITCH "A" CIRCUIT RANGE/PERFORMANCEDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Acceleration is poor ...

Inspection
LIGHTING SYSTEM > Rear Height SensorINSPECTION1. Connect three dry cell batteries (1.5 V) in series.NOTE:• Use new dry-cell batteries.• Using a circuit tester, check that the initial voltage of each dry-cell battery is 1.6 V or more. And also check that the voltage of three batteries ...

Washing the underbody
Chemicals, salts and gravel used for deicing road surfaces are extremely corrosive, accelerating the corrosion of underbody components, such as the exhaust system, fuel and brake lines, brake cables, floor pan and fenders, and suspension. Thoroughly flush the underbody and inside of the fen ...