Subaru Crosstrek manuals

Subaru Crosstrek Owners Manual: Outside temperature indicator

Outside temperature indicator

  1. U.S.-spec. models
  2. Except U.S.-spec. models

The outside temperature indicator shows the outside temperature in a range from −40 to 1228F (−40 to 508C).

The indicator can give a false reading under any of the following conditions.

Road surface freeze warning indication

Road surface freeze warning indication

  1. U.S.-spec. models
  2. Except U.S.-spec. models

When the outside temperature drops to 378F (38C) or lower, the temperature indication flashes to show that the road surface may be frozen.

If the outside temperature drops to 378F (38C) or lower while the display is giving an indication other than the outside temperature, the display switches to the outside temperature indication and flashes for 5 seconds before returning to its original indication.

If the display is already indicating an outside temperature of 378F (38C) or lower when the ignition switch is turned to the "ON" position, the indication does not flash.

NOTE

The outside temperature indication may differ from the actual outside temperature. The road surface freeze warning indication should be treated only as a guide. Be sure to check the condition of the road surface before driving.

Information display (if equipped)
NOTE For models with color multi function display, refer to "Multi function display" Outside temperature indicator Driving information display Clock With the ignition switch in the "A ...

Driving information display
Information display selection knob With the ignition switch in the "ON" position, each successive press of the information display selection knob switches the display in the following seq ...

Other materials:

Removal
CLUTCH SYSTEM > Clutch Pipe and HoseREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).4. Loosen the clamp (C) which connects the air intake boot and throttle body.5. ...

Replacing bulbs
WARNING Bulbs may become very hot while illuminated. Before replacing bulbs, turn off the lights and wait until the bulbs cool down. Otherwise, there is a risk of sustaining a burn injury. CAUTION Replace any bulb only with a new bulb of the specified wattage. Using a bulb of differe ...

Removal
FUEL INJECTION (FUEL SYSTEMS)(H4DO) > Engine Wiring HarnessREMOVAL1. Release the fuel pressure. Fuel > PROCEDURE">2. Disconnect the ground cable from battery.3. Remove the intake manifold. Intake Manifold > REMOVAL">4. Disconnect the connector from the engine.• Struc ...

© 2016-2026 Copyright www.sucross.com