Subaru Crosstrek Service Manual: Installation
SECURITY AND LOCKS > Rear Outer Handle
INSTALLATION
1. Before installation, check the following items.
• Lever is free from deformation.
• Grease is applied sufficiently to lever joints.
If grease is insufficient, add it as necessary before assembling.
• If the lever is faulty, replace the rear outer handle.
• If the lever is deformed, replace the latch & actuator assembly - rear.
2. Install each part in the reverse order of removal.
CAUTION:
Do not reuse the screws of the latch and actuator assembly - rear. Always replace with a new part.
Tightening torque:
Refer to “COMPONENT” of “General Description”. General Description > COMPONENT">
Removal
SECURITY AND LOCKS > Rear Outer HandleREMOVAL1. Raise the glass assembly - rear door to the top position.2. Disconnect the ground cable from battery. NOTE">3. Remove the trim panel - rear ...
Receiver
...
Other materials:
Dtc b2a0a red led circuit
TELEMATICS SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC B2A0A RED LED CIRCUITDiagnosis start condition:When ACC is ON.DTC detecting condition:• Current in LED is less than 1 mA. (Improper LED connection, etc.)• Current is more than 200 mA for at le ...
Front passenger's SRS frontal airbag
The front passenger's SRS frontal airbag
uses a dual stage inflator. The inflator
operates in different ways depending on
the severity of impact.
The occupant detection system sensor is
installed under the seat upholstery and
monitors the physique and posture of the
front passenger. Using t ...
Dtc p062f internal control module eeprom error
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P062F INTERNAL CONTROL MODULE EEPROM ERRORDTC DETECTING CONDITION:Detected when two consecutive driving cycles with fault occur.TROUBLE SYMPTOM:TCM EEPROM malfunctionSTEPCHECKYESNO1.CHECK ...
