Subaru Crosstrek Service Manual: Rear outer handle

Installation

SECURITY AND LOCKS > Rear Lock ButtonINSTALLATIONCAUTION:Make sure that the harness grommet is securely installed.If not properly installed, this may cause leaks.Install each part in the reverse or ...

Inspection

SECURITY AND LOCKS > Rear Outer HandleINSPECTIONCheck if the outer handle operates normally.If the lever is faulty, replace the handle - door outer. ...

Other materials:

Dtc p050a cold start idle control system performance
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P050A COLD START IDLE CONTROL SYSTEM PERFORMANCEDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Engine keeps running at higher speed than specified ...

Removal
LIGHTING SYSTEM > Front Turn Signal Light BulbREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Turn the steering wheel in the opposite direction from the parts to be removed. Then remove the clips and turn over the mud guard - front.3. Remove the bulb socket and front turn si ...

Dtc b1613 front sub sensor rh initialization error
AIRBAG SYSTEM (DIAGNOSTICS) > Diagnostic Chart with Trouble CodeDTC B1613 FRONT SUB SENSOR RH INITIALIZATION ERRORDiagnosis start condition:Ignition voltage is 10 V to 16 V.DTC detecting condition:• Open or short circuit in harness of front sensor bus (RH)• Front sub sensor (RH) is fa ...