Subaru Crosstrek Service Manual: Tire pressure monitoring system (diagnostics)
- Control module i/o signal
- Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc c2021 tire 1 air pressure low (normal mode)
- Dtc c2521 speed abnormal
- Dtc c2022 tire 2 air pressure low (normal mode)
- Dtc c2023 tire 3 air pressure low (normal mode)
- Dtc c2024 tire 4 air pressure low (normal mode)
- Dtc c2121 transmitter 1 no data
- Dtc c2122 transmitter 2 no data
- Dtc c2123 transmitter 3 no data
- Dtc c2124 transmitter 4 no data
- Dtc c2221 transmitter 1 pressure data abnormal
- Dtc c2222 transmitter 2 pressure data abnormal
- Dtc c2223 transmitter 3 pressure data abnormal
- Dtc c2224 transmitter 4 pressure data abnormal
- Dtc c2321 transmitter 1 function code abnormal
- Dtc c2322 transmitter 2 function code abnormal
- Dtc c2323 transmitter 3 function code abnormal
- Dtc c2324 transmitter 4 function code abnormal
- Dtc c2421 transmitter 1 battery voltage low
- Dtc c2422 transmitter 2 battery voltage low
- Dtc c2423 transmitter 3 battery voltage low
- Dtc c2424 transmitter 4 battery voltage low
- General description
- Read current data
- Subaru select monitor
- Tire pressure warning light / trouble indicator light illumination pattern
- Inspection
- Tire pressure warning light is 25 times blinking and turn on
- Tire pressure warning light does not come on
- Tire pressure warning light does not come off
- Basic diagnostic procedure Procedure
- Clear memory mode Operation
- Display transmitter (id) Operation
- Electrical component location Location
- General diagnostic table Inspection
- Inspection mode Procedure
- List of diagnostic trouble code (dtc) List
- Read diagnostic trouble code (dtc) Operation
- Register transmitter (id) Operation
Inspection mode Procedure
TELEMATICS SYSTEM (DIAGNOSTICS) > Inspection ModePROCEDUREIt is possible to diagnose the DTC by performing the indicated inspection mode.After correcting the DTC, perform a necessary inspection mod ...
Other materials:
Dtc p0751 shift solenoid "a" performance/stuck off
CONTINUOUSLY VARIABLE TRANSMISSION (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0751 SHIFT SOLENOID "A" PERFORMANCE/STUCK OFFDTC detecting condition:Detected when two consecutive driving cycles with fault occur.Trouble symptom:• Shift control malfunc ...
Auto light sensor sensitivity setting
1. Perform the preparation steps according
to "Preparation for car settings"
2. Operate the " " or "
" switch to
select the "Auto Light Sensor" item. Then
push the button.
3. The current setting will be displayed.
Push the button to enter the
selection
mode.
4. Selec ...
Type C and D
1. Depress the "AUTO" button. The
indicator light "FULL AUTO" on the display
illuminates.
2. Set the preferred temperature using
the temperature control dial.
NOTE
The controllable temperature range
may vary depending on the regional
specifications of the vehicle.
If you operate any ...
