Subaru Crosstrek Service Manual: Dtc c2424 transmitter 4 battery voltage low

DTC DETECTING CONDITION:

Detected when power supply voltage failure signal is received from each transmitter.

TROUBLE SYMPTOM:

Tire pressure warning light blinks 25 times and then illuminates.

1.REPRODUCTION OF FAILURE.

1) Perform the drive test.

Drive the vehicle at 40 km/h (25 MPH) or faster for at least 10 minutes.

2) Read the DTC of tire pressure monitoring. Read Diagnostic Trouble Code (DTC) > OPERATION">

Is DTC displayed as “Present fault”?

Diagnostic Procedure with Diagnostic Trouble Code (DTC) > DTC C2424 TRANSMITTER 4 BATTERY VOLTAGE LOW">Go to Step 2.

When DTC is displayed as “Past faults”, the system has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.

NOTE:

In this case, there may be temporary poor communication due to radio wave environment inside/outside the vehicle.

2.CHECK TRANSMITTER.

1) Replace all transmitters and register their IDs. Register Transmitter (ID) > OPERATION">

2) Perform the Clear Memory Mode. Clear Memory Mode">

3) Perform the Inspection Mode. Inspection Mode">

Is the fault eliminated?

Internal battery of the transmitter had worn out.

Replace the TPMS & keyless entry CM or TPMS CM. Tire Pressure Monitoring System">

Dtc c2423 transmitter 3 battery voltage low

General description

Other materials:

Removal
MANUAL TRANSMISSION AND DIFFERENTIAL(5MT) > Manual Transmission AssemblyREMOVAL1. Disconnect the ground cable from battery.2. Remove the clip (A) from the air intake boot.3. Loosen the clamp (B) connecting the air intake boot and air cleaner case (rear).4. Loosen the clamp (C) which connects the ...

Inspection
CONTINUOUSLY VARIABLE TRANSMISSION(TR580) > Drive Pinion Shaft AssemblyINSPECTION• Make sure that all component parts are free of scratches, holes and other faults.• Check the tooth contact. Drive Pinion Shaft Assembly > ADJUSTMENT">• Apply CVTF to bearing and rotate ...

Removal
SECURITY AND LOCKS > Rear Door Latch and Door Lock Actuator AssemblyREMOVAL1. Disconnect the ground cable from battery. NOTE">2. Remove the trim panel - rear door. Door Trim > REMOVAL">3. Remove the sealing cover - rear door. Rear Sealing Cover > REMOVAL">4. Remov ...