Subaru Crosstrek Service Manual: Diagnostic procedure with diagnostic trouble code (dtc)
- Dtc c2021 tire 1 air pressure low (normal mode)
- Dtc c2521 speed abnormal
- Dtc c2022 tire 2 air pressure low (normal mode)
- Dtc c2023 tire 3 air pressure low (normal mode)
- Dtc c2024 tire 4 air pressure low (normal mode)
- Dtc c2121 transmitter 1 no data
- Dtc c2122 transmitter 2 no data
- Dtc c2123 transmitter 3 no data
- Dtc c2124 transmitter 4 no data
- Dtc c2221 transmitter 1 pressure data abnormal
- Dtc c2222 transmitter 2 pressure data abnormal
- Dtc c2223 transmitter 3 pressure data abnormal
- Dtc c2224 transmitter 4 pressure data abnormal
- Dtc c2321 transmitter 1 function code abnormal
- Dtc c2322 transmitter 2 function code abnormal
- Dtc c2323 transmitter 3 function code abnormal
- Dtc c2324 transmitter 4 function code abnormal
- Dtc c2421 transmitter 1 battery voltage low
- Dtc c2422 transmitter 2 battery voltage low
- Dtc c2423 transmitter 3 battery voltage low
- Dtc c2424 transmitter 4 battery voltage low
Wiring diagram
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Control Module I/O SignalWIRING DIAGRAMRefer to “Tire Pressure Monitoring System” in the wiring diagram. Tire Pressure Monitoring System ...
Dtc c2021 tire 1 air pressure low (normal mode)
TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC C2021 TIRE 1 AIR PRESSURE LOW (NORMAL MODE)NOTE:Refer to DTC C2024 for diagnostic procedur ...
Other materials:
Removal
ENTERTAINMENT > AntennaREMOVAL1. RADIO/TELEMATICS ANTENNACAUTION:Before handling the airbag system components, refer to “CAUTION” of “General Description” in “AIRBAG SYSTEM”. General Description > CAUTION">1. Disconnect the ground cable from battery ...
Removal
LIGHTING SYSTEM > Back-up Light BulbREMOVAL1. CROSSTREK MODEL1. Disconnect the ground cable from battery. NOTE">2. Remove the light assembly - rear combination.CAUTION:Be careful not to damage the clips.(1) Release the bolts and clips, then pull out the light assembly - rear combination ...
Installation
EMISSION CONTROL (AUX. EMISSION CONTROL DEVICES)(H4DO) > EGR CoolerINSTALLATION1. Set the gasket to the stud bolt.NOTE:Use a new gasket.2. Temporarily tighten the bolts securing the EGR cooler to the EGR control valve and the cylinder head RH, and tighten in numerical order.NOTE:Use a new gasket. ...
