TIRE PRESSURE MONITORING SYSTEM (DIAGNOSTICS) > Tire Pressure Warning Light / Trouble Indicator Light Illumination Pattern
TIRE PRESSURE WARNING LIGHT DOES NOT COME ON
DETECTING CONDITION:
Defective combination meter
TROUBLE SYMPTOM:
When the ignition switch is turned to ON, the tire pressure warning light does not turn on (for approx. 2 seconds).
| STEP | CHECK | YES | NO |
1.CHECK DIAGNOSTIC TROUBLE CODE (DTC).
Connect the Subaru Select Monitor, and read the Diagnostic Trouble Code. Read Diagnostic Trouble Code (DTC) > OPERATION">
Is diagnostics code (DTC) displayed?
Perform the diagnosis according to the DTC. List of Diagnostic Trouble Code (DTC)">
Replace the combination meter. Combination Meter > REMOVAL">
Tire pressure warning light is 25 times blinking and turn on
Tire pressure warning light does not come offComponent
COOLING(H4DO) > General DescriptionCOMPONENT1. WATER PUMP(1)Water pump pulley(13)Clip(25)Gasket(2)Water pump ASSY(14)Water pipe hose RH(26)Engine coolant temperature sensor(3)Gasket(15)Water pipe ASSY (CVT model)(27)EGR control valve(4)Thermostat (engine side)(16)Preheater hose A(28)O-ring(5)Gask ...
Caution
STARTING/CHARGING SYSTEMS(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.2. Protect the vehicle using a seat ...
Removal
BRAKE > Front Brake PadREMOVAL1. Lift up the vehicle, and then remove the front wheels.2. Remove the front brake pad.(1) Remove the caliper bolt on the lower side.(2) Raise the caliper body assembly and support it.NOTE:Do not disconnect the brake hose from the caliper body assembly.(3) Remove the ...