Subaru Crosstrek Service Manual: Removal
BRAKE > Front Brake Pad
REMOVAL
1. Lift up the vehicle, and then remove the front wheels.
2. Remove the front brake pad.
(1) Remove the caliper bolt on the lower side.
(2) Raise the caliper body assembly and support it.
NOTE:
Do not disconnect the brake hose from the caliper body assembly.
(3) Remove the brake pad from support - front disc brake.
Inspection
BRAKE > Front Brake PadINSPECTION1. Check the pad thickness (A).NOTE:• Always replace the pads of both wheels and both sides as a set.• Replace pad clips if they are twisted or worn.&bu ...
Installation
BRAKE > Front Brake PadINSTALLATIONNOTE:Before installation, remove mud and foreign matter from the caliper body assembly and support - front disc brake.1. Check the brake pad. Front Brake Pad > ...
Other materials:
Dtc p0222 throttle/pedal position sensor/switch "b" circuit low
ENGINE (DIAGNOSTICS)(H4DO) > Diagnostic Procedure with Diagnostic Trouble Code (DTC)DTC P0222 THROTTLE/PEDAL POSITION SENSOR/SWITCH "B" CIRCUIT LOWDTC detecting condition:Immediately at fault recognitionTrouble symptom:• Improper idling• Poor driving performance• Engin ...
Caution
IGNITION(H4DO) > General DescriptionCAUTION• Prior to starting work, pay special attention to the following:1. Always wear work clothes, a work cap, and protective shoes. Additionally, wear a helmet, protective goggles, etc. if necessary.2. Protect the vehicle using a seat cover, fender cov ...
Trailer towing tips
CAUTION
On Subaru Ascent models equipped with BSD (Blind Spot Detection) and
RCTA (Rear Cross Traffic Alert), it is recommended to deactivate the "Rear Vehicle
Detection (BSD/RCTA)" function when towing a trailer. The presence of the trailer
may interfere with radar signals, r ...
